|
INSTRUCTIONS
Use the ruler to measure a 12-14 inch
length of tiger tail wire and cut with the wire cutters. Put
one of the small beads onto the wire and place it at the middle.
Fold the wire in half. The small bead should be right at the
fold. Now arrange the rest of the beads how you would like
sliding the beads onto both wires. Continue as shown in the
picture. Slide the crimp bead through both wires, and then
add the key ring. Put the two wires through the crimp bead
again. With needle nose pliers pull both wires, till it is
quite snug. Then crimp the crimp bead, by pinching with the
needle nose pliers. Trim any extra wire.
View
Printable Version
|
