|
INSTRUCTIONS
Place the film canister
lid on an old block of wood. With the nail and hammer punch
a hole into the center of the lid. It is best to do this on
the floor. Just hit it hard enough so the nail goes through
and pulls out easy. Next cut your cord or ribbon to a 32 inch
length and fold in half. Fold your little piece of wire in
half too. You are going to use the wire to help thread your
cord, or ribbon into the hole in the lid. Slip the wire over
the cord at the fold, just give the wire a little twist, but
not tight. It will kind of look like a needle. Thread the
wire and cord through the top of the lid. Remove the wire
and tie a knot just above the fold of the cord, or ribbon.
Slide the knot up to be snug against the inside of the lid.
You are pretty much done. Decorate the canister with small
sticker borders, or small stickers. Fill it with candy or
tiny treasures. Put the lid on, and tie the two loose ends
around your neck. You might need a little help with that.
The film canister necklace makes good party favors. Ask local
photo centers if they have any discarded ones.
View
Printable Version
|
